|
Post by baotian on Oct 15, 2005 13:29:08 GMT
Hi All i noticed that when i went on my ped this morning that there is a creaking noise when i apply the brakes, sit on it, or even accelerate or go over bumps, its not a rattle noise, its definitely creaking, and in halfords they sell motorbike grease, which is in a spray format, shall i spray the hole bike over (most of the metal parts, eg suspension etc) or is that not a good idea. also my rear shock suspension is not good at taking bumps, i need it to be for firm, as it bounces around to much, is there a way of tightening it up? or is it because I'm 16 stone cheers all
|
|
|
Post by Ginger Phil on Oct 15, 2005 13:54:13 GMT
My Taishan used to creak over bumps but I wouldn't recommend spraying stuff all over the bike unless you know where you're spraying it. #sprint# The suspension on these Chinese scooters is a bit like Buckaroo, enjoy it. #afro#
|
|
|
Post by baotian on Oct 15, 2005 14:12:31 GMT
oh right, so im not the only one that has suspension that even if you go over a stone, goes down about inches, and then bounces up again lol its a bit like this =
|
|
|
Post by Ginger Phil on Oct 15, 2005 14:22:07 GMT
Mine was exactly the same, sometimes I used to have a right laugh being tossed.................................in the air.
|
|
|
Post by hypojam on Oct 15, 2005 14:25:40 GMT
Im Finding my rear suspension to be too hard!
|
|
|
Post by baotian on Oct 15, 2005 14:34:44 GMT
lol, maby becasue your 11 stone rarther then 16 stone btw gingerphil, its not su much being thrown in the air, its more like when it goese over a bump, it feels like its going to bottom out, and the centre stand hits the ground alot as well , i hope its not my wait causing all this lol is there a way of tightening it up?
|
|