|
Post by mcole on Jan 17, 2006 13:41:27 GMT
Hi folks, Thought id say hi. Been lookin aroun here ... nice. Good to see a forum like this. I have a few questions for you electrical gurus. I am taking the electrical system and engine off of my 139qmb scooter and setting it up to drive a go cart axle, however i was wondering how to set up the wiring for just the elec start with ignition. In other words i'm getting rid of the lights, blinkers, horn, etc... any ideas, schematics, etc... all I can find is this: scootusa.com/wiring_diagram_for_ts50qt_with_4.htm
|
|
|
Post by BillyGreen1973 on Jan 17, 2006 16:59:17 GMT
Hi, welcome aboard. You'll have to keep us informed about how you get on with your project. You can download the full service manual, and users handbook from this link mysite.wanadoo-members.co.uk/baotiandocs/manuals.zipIt is quite a big download (18mb) but well worth it for the info that's on there.
|
|
|
Post by chcknugget on Jan 17, 2006 19:13:12 GMT
It might be hard because the ignition doesn't run straight from the primary coil to the secondary, but through the cdi. I think that means you need a battery or at least a voltage regulator for it to work.
|
|
|
Post by Ginger Phil on Jan 20, 2006 20:23:28 GMT
Welcome aboard!!
|
|