Post by stulaine on Jun 19, 2006 13:45:42 GMT
--------------------------------------------------------------------------------
Dear All
I followed Billy & Ginger's deristrict guides for the carburettor, but found there were no washers on the end of the needle, just a plain needle held in place by a white plastic piece on the top of it.
I took the brass screw off from under the cover as I thought that would still be correct. It now seems to have a little more power on the hills. I replaced it as I found it, but noticed on the exploded diagram, on the link to the manual part one chapter 5 ,that the white thing is shown under the top of the needle. I thought I must have made a mistake, so re assembled it as shown, but it would not tick over when cold, and there seemed to be some slow spots. I put it back with the white thing on top and all is well again. What did I do wrong?
stulaine
« Last Edit: Today at 2:40pm by stulaine »
