joe
Regular
Posts: 48
|
Post by joe on Jan 24, 2006 15:52:53 GMT
Has anyone put the 80cc big bore kit in there bike? If yes was it hard to put in? Is there a increase in power ? How fast does it go now?
|
|
|
Post by BillyGreen1973 on Jan 24, 2006 18:34:20 GMT
I have put an 80cc kit on my bike.
It's not that difficult to do, you just have to be methodical and make sure you get each step correct before moving on to the next. It took me around 5 hours in total.
There is deffinatly a power increase, and it sounds bigger and more powerful, However I have only increased top speed by about 3mph! BUT I haven't set the fuel/air mix yet, and I'm going to change the rollers for heavier ones now I have the extra power for acceleration.
|
|
|
Post by chcknugget on Jan 24, 2006 21:31:55 GMT
I have put an 80cc kit on my bike. It's not that difficult to do, you just have to be methodical and make sure you get each step correct before moving on to the next. It took me around 5 hours in total. There is deffinatly a power increase, and it sounds bigger and more powerful, However I have only increased top speed by about 3mph! BUT I haven't set the fuel/air mix yet, and I'm going to change the rollers for heavier ones now I have the extra power for acceleration. Yes, these are the same results I had. You'll find that you would be able to do it in an hour now that you've done it before. I had to replace my head last november, adn it only took my 45 minutes to do the whole teardown!
|
|