|
Post by hypojam on Sept 13, 2005 16:20:57 GMT
My little taishan is having problems at low speeds The bikes transmission is lowering the gears too quickly, thats causing the thing not too rev enough, so when im on a slight hill i cant gain any acceleration Is there any easy way of fixing this and is anyone else having same problem
|
|
|
Post by biglee on Sept 13, 2005 19:36:36 GMT
mine has been like that since i ve had it but i have just had some rollers delivered today so hopefully that will make it better.
|
|
|
Post by BillyGreen1973 on Sept 14, 2005 15:07:34 GMT
I'ev also got some rollers to fit but can't get the bloody nut off the Driving pully.
Good luck!!
Let me know how you get on.
|
|
|
Post by biglee on Sept 16, 2005 15:35:05 GMT
just had my rollers fitted at motorcycle shop and the scooter is the same as before, i put 6gram ones in what weight have you got
|
|
|
Post by BillyGreen1973 on Sept 16, 2005 23:25:15 GMT
I have a set of 5.1gm and a set of 6gm, so from what you have said I may as well just put the 5.1's in.
How long did it take them? and did they charge much?
|
|
|
Post by hypojam on Sept 17, 2005 21:28:48 GMT
My stupid taishan! It was going about 10MPH up this slight hill I think the cold weather was affecting it quite badly Ive readjusted the tappets! the intake valve gap looked a bit tight Might explain why i was having so much trouble getting it started when it was hot Hopefully it might cure the up hill struggle problem
|
|
|
Post by biglee on Sept 18, 2005 16:57:25 GMT
i would go with the lighter ones i wish i had, it cost £25 and it tuck about 40mins
|
|
|
Post by chcknugget on Sept 20, 2005 23:24:21 GMT
My rollers came in a pack. The dude I bought I bought them from said that some trial and error will happen, and that different combinations of rollers should be tried. First I have to get my scooter running again and get a hold of an impact wrench to pull the stupid variator!
|
|