Indicators on BT50QT-9 Problem

[hawko]

I recently recieved my Baotian and on unpacking etc i put it together and noticed that my left rear indicator wasnt working, all the others were so i assumed that it was a dead bulb so took it apart today, and a black plastic washer that lines up the wire from the bike to the bulb was in bits, so i took that out and fashioned a new one so the wire lines up with the bulb put the bulb back in and none of my indicators would work at all!!!!!!

now i know the bike battery has very little charge (cant use electric start yet), but i was running the indicators off it perfectly before so not sure if its because theres no power at all that they arnt working or because somethings gone wrong.

for a time like a previous post as i was fiddling trying to get these lined up they wouldnt flash just stayed on.

Anyone know anything about this? or can help?

[ads218]

I had a similar problem on a rear Taishan. What i found was that two wires go to the bulb holder . One goes to the centre of the bulb holder and the other goes to the outside of the holder and is soldered to the outer edge. This had come loose and meant that it had lost its 'Earth'. All i did was re-solder and indicator worked fine.
Hope this is of some help M8.