|
Post by Gavin on Dec 22, 2005 11:49:58 GMT
If you are removing your battery for charging, and you are getting fed up with the fiddly connections on the battery terminals, then using wire cullers, cut a small section from the 'O' teminals on the leads that go to the battery, and make them into 'U' terminals. This allows you to remove and reconnect the terminals, without removing the fixing screw fully. It makes removing and replacing the battery so much easier.
|
|
|
Post by hypojam on Dec 22, 2005 12:33:58 GMT
Top Tip #taxman2#
|
|