|
Post by fimaks on Aug 27, 2006 9:25:25 GMT
After a ride my bt-qt10 dies and can't start.If I remove the spark with i replace with NGK it with start and after a ride dies again.And same procedure again if i want to start. need help ASAP
|
|
|
Post by cb50j on Aug 27, 2006 9:30:00 GMT
could be down to either mixture or valves needing adjusted
look around, there are lots of similar posts and numerous replies to them
..... C
|
|
|
Post by fimaks on Aug 27, 2006 13:29:46 GMT
i still have the problem, can you please give me a direct link for other posts?
|
|
|
Post by cb50j on Aug 27, 2006 13:52:38 GMT
"i still have the problem" have you checked your valve clearances/tried adjusting the mixture? if it starts easily with a fresh spark plug,it's more likely to be flooding/autochoke problem ......... C
|
|
|
Post by fimaks on Aug 28, 2006 0:34:34 GMT
can you tell me how can i set the mixture exactly and how to check or repair autochoke?
|
|
|
Post by enu06 on Aug 28, 2006 8:07:08 GMT
Carb setting: Go to 'engine & derestricting' see carb setting by Ally 1756, set the MIDDLE screw by turning in fully, then turning out to 1 1/2 to 2 1/2 turns, your best running should be inbetween these. You may need to set the slow running tickover screw after doing this, this is the adjuster screw on the carb by the throttle cable,. Valves, go to 'hints tips & diy' see at the top setting valve clearances.
|
|